BIXOLON STP-103II - Manual (Page 16)

Rev. 1.02 - 16 -
STP-103II
5. Self Test
5-1 Self Test Printing
* Starting the self test
Mount the roll, close the cover, and turn on the printer while pressing the PAPER FEED
button to start the self test.
The self test printing will print the current settings of the printer including the following
information.
- Software version control
- DIP switch setting
* Preparation state
After printing the current status
of the printer, the printer prints the message “Please press
the FEED BUTTON”. The LED blinks and the printer enters the test print preparation mode.
5-2 Finishing Self Test
After the test printing is completed, the printer notifies the end of test printing by printing
the " ** TEST COMPLETED ** " message.
If the self test is not completed, reboot the printer.