Atlona AT PA100 G2a4 - Manual (Page 4)

4
Input Ports 2 x RCA connectors
1 x 3.5mm Audio
1 x 3.5mm IR
1 x Captive Screw MIC
1 x Captive Screw RS-232
Output Ports 1 x Captive Screw Audio
1 x 3.5mm Loop Out
Dimensions (HxWxD) 1.5 x 3.78 x 3.43 (inch) or 38 x 96 x 87 (mm)
Weight 0.66lbs or 0.3kg
Power consumption 3.6W
Audio
Gain:
32dB
Frequency Range: 20Hz to 20KHz
Signal/Noise Ratio: 80dB (at max output)
Total Harmonic Distortion: 1% (1KHz), 0.3% (20KHz) -- at nominal levels
Input Impedance: Input 1&2: >10KΩ
MIC Input Impedance: 48V: 35KΩ
MIC: 10KΩ
LINE: 75KΩ
Output Impedance: 3.5mm Loop Out: 50Ω stereo
Speaker out: 4 ~ 8Ω Amplifier
Stereo Channel Separation: >75dB from 20Hz to 20KHz
Common Mode Rejection Ratio: >70dB from 20Hz to 20KHz
MIC Audio Detection Delay: 1ms
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
Specifications
Panel Description
Front Panel
1. Audio output format switch: Use to switch between Stereo, Dual Channel Mono, and
Bridged audio outputs
2. 3.5mm IR: Connect optional IR receiver here for use with optional IR remote (AT-PA1-IR)
3. Captive Screw RS-232: Connect RS-232 here for control
4. Captive Screw Input: Connect a MIC
5. Audio input switch: Switch between 48V Phantom powered condenser MIC, Dynamic
MIC, or LINE
6. L/R audio: Connect Analog audio into this port
7. 3.5mm audio: Connect Analog audio into this port
1 2 3
4 5 6 7