Atlona AT HDVS TX User Manual

Page 6

Text mode
Original mode

atlona.com

Toll free: 1-877-536-3976

Local: 1-408-962-0515

Set Up

Control software and instructions for use can be found on the AT-HDVS-TX webpage on atlona.
com (can only be used with compatible receivers - AT-HDVS-RX)

URL: http://www.atlona.com/HDVS-TX.html

(instructions/software found under the “Downloads” tab)

Control Software

RS-232 control is easiest when used with the HDVS-RX receiver.

However when used with appropriate power supply and HDBaseT receiver with RS-232 capabilities,
the display power button can be used to transmit the following commands:

Projector On/Off

WP_Display[a]$

[a] ? , On , Off Display On/Off control

To change inputs, the HDVS-TX-WP should receive these commands:

WP_Input[a]$

[a] ? , Hdmi , Vga Select input source (HDVS-TX-WP)

The port settings for the control device are:

115200 bps, 8 bit data length, No parity bit, 1 bit stop-bit, No flow control.

Note: Each command is terminated with a carriage return