Atlona AT HDVS TX - Manual (Page 3)

3
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
Introduction
Atlona HDVS transmitter was designed to smooth the transition from analog to digital displays in
schools and businesses, allowing advanced HDMI display devices to be used with the many VGA
computers still in use. HDBaseT and power over category cable (PoCc™) allow signal and power
over a single category cable, with RS-232 control capability.
Package Contents
Features
Features when used with HDVS-RX
• 1 x AT-HDVS-TX
• 1 x 24V/2.7A DC Power Supply
• 1 x Captive Screw Connector (Power)
• 1 x Pair of undertable mount ears
• 1 x User Manual
• 2 HDMI and 1 VGA/analog audio inputs
• Auto switching for easy input management
• Extends resolutions of 1080p or 1920x1200 up to 230ft*
• 3-Way power
Power the transmitter with included power supply
Power the transmitter with compatible receivers
Power a receiver with PoCc when connected to included power supply
• Embeds analog audio with VGA onto HDBaseT output
• Firmware upgrade via USB for easy field service
• Undertable mounting ears
• PoCc (Power over Category cable), receive power from the receiver
• RS-232 display control and input selection
• De-embedded balanced 2Ch audio on output to send to an amplifier (Ex. AT-PA100-G2)
Auto Switching
Compatibility
Built in auto-switching for easier selection. Power on and off sources to switch inputs.
Note: A 5V hot plug event is used to trigger input selection. If a 5V signal is not detected the souce
will not change. Many VGA sources do not include the 5V hot plug.
This product is compatible with all of Atlona’s HDBaseT receivers. These include AT-HDRX, AT-
HDRX-IR, AT-HDRX-RSNET, AT-PRO3HDREC and associated wall plates. It may also be used with
displays with HDBaseT inputs.
Note: It is possible that some displays may have issues with VGA sources that don’t have the same
timings as HDMI sources used with the same displays.