Atlona AT DVISync - Manual (Page 5)

4 www.atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
2. Rear Panel
3. Bottom Panel
Caution! Do not plug DVI cable into PC-DVI connector when you are changing from one operation
mode to another
5. RS-232: Link your computer with the AT-DVISync here in
order to read/write EDIDs from/ to displays.
6. PC-DVI: Connect to Desired PC
DIP SWITCH
1 2 Mode
OFF ( ) OFF ( ) Reserved mode, not in use.
OFF ( ) ON ( )
Recording: Connect desired monitor to the DVI-monitor connector. Once the recording
process is completed, the AT-DVISync will have copied the EDID from the monitor into
its flash memory and the green LED will turn off.
ON ( ) ON ( )
Reset to default: Write the default EDID back into the AT-DVISync to replace the existing
EDID in the AT-DVISync. Once the writing process is complete, the green LED will turn
off.
ON ( ) OFF ( ) Connection mode: Set DIP switches at this position before you connect your computer
to the AT-DVISync
Note: To avoid initiating undesired errors during switching between modes (e.g. changing from Recording mode to
Connection mode might overwrite the EDID of the display in the AT-DVISync by the default EDID), please unplug the
power cord before changing one of the above modes. Plug in the power cord after you have changed the position of
the DIP switches.