Atlona AT HD50SS - Manual (Page 10)

8
Receiver Unit  AT-HDRS
Input Panel
+5V DC: Connect to 5V DC power supply unit.
HDMI Signal IN: Connect to the HDMI Signal OUT on the sender unit AT-HD50SS or
AT-HD50RSL with a solid Cat-5/5e/6 UTP/STP cable.
Output Panel
Signal Level: Adjust the 8-level signal equalization control to the received HDMI signals. The
HDMI signal level varies from 0 (strongest) to 7 (weakest) for respective transmission
length from longest possible range to short distance. Dial the Signal Level from 7 to 0
and stop turning the rotary switch whenever the audio/video is playing normally.
Inappropriate signal level setting may cause overpowering issues that would shorten the
product’s life significantly!
HDMI OUT: Connect to a HDMI display or projector with a HDMI male-male cable.
Receiver Unit  AT-HD15SRS
Connect to the RJ-45 port of the AT-HD15SRS to the HDMI Signal OUT on the sender unit AT-
HD50SS or AT-HD50RSL with a solid Cat-5/5e/6 UTP/STP cable and plug the HDMI port to a
HDMI display/projector or the HDMI output port on AT-HD50SS or AT-HD50RSL for HDMI over
CAT5e/6 transmission.