Connecting to a power source, Onnecting, Ower – Agema AG7448CU-R User Manual
Page 17: Ource
- 17 -
C
HAPTER
2
|
Installing the Switch
Connecting to a Power Source
C
ONNECTING
TO
A
P
OWER
S
OURCE
To connect a switch to a power source:
1.
Insert the power cable plug directly into the AC socket of a PSU located at the back of
the switch.
Figure 14: Power Socket
2.
Plug the other end of the cable into a grounded, 3-pin, AC power source.
3.
Check the PSU and front-panel LEDs as the device is powered on to be sure that AC
power is being received and the PS1/PS2 LED is on. If not, check that the power cable
is correctly plugged in.
4.
Repeat steps 1 and 2 when a second PSU module is installed.
Two installed PSU modules operate in a load-sharing mode and provide 1+1
redundancy.
NOTE:
For International use, you may need to change the AC line cord. You must use
a line cord set that has been approved for the socket type in your country.
AC OK
Power socket