Horizontal surface mounting – Agema AG7448CU-R User Manual
Page 14
- 14 -
C
HAPTER
2
|
Installing the Switch
Mounting
H
ORIZONTAL
S
URFACE
M
OUNTING
The switch includes four pre-installed rubber feet for horizontal surface mounting.
To mount devices on a horizontal surface, follow these steps:
1.
Attach the four adhesive feet to the bottom of the first switch.
Figure 10: Attaching the Adhesive Feet
2.
Set the device on a flat horizontal surface near an AC power source, making sure there
are at least two inches of space on all sides for proper air flow.
3.
If installing a single switch only, go to Connecting to a Power Source.
4.
If installing multiple switches, attach four adhesive feet to each one, then place each
device squarely on top of the one below, in any order.