ABUS Technologies LPI-T Loop Powered Indicator - Manual (Page 8)

ABUS TECHNOLOGIES INC.
8
LPI-T
4. Decimal Point
Press button “A”, unit is displayed.
 “A+B” menu item for setting.
 “A” to move the decimal towards left; “B” to move it towards right.
 “A+B” to confirm and store setting and return to the menu item.
5. Damping
Press button “A”, unit is displayed.
 “A+B” menu item for setting.
 “A” to increase it by step of 0.5s and “B” to reduce it by step of 0.5s. (Min=0s,
Max=20s, step 0.5s)
 “A+B” to confirm and store setting and return to the menu item.
6. Alarm
Press button “A”, unit is displayed.
 “A+B” menu item for setting.
 “A” or “B” to change the setting either “on” or “off”. “on” means the parameter
followed is valid, and the Alarm was expressed by the twinkle of the last decimal
point. And “off” cancel the alarm function.
 “A+B” to confirm and store setting and return to the menu item.
7. First alarm point
Press button “A”, unit is displayed. It is configured in percentage of span.
8. Second alarm point
Press button “A”, unit is displayed. The method of setting is the same as
step 7.
9. The direction of first alarm point
Press button “A”, unit is displayed.
 “A+B” menu item for setting.
 “A” or “B” to change the setting either “up” or “down”. “up” means alarm while
the value change from small to big, and “down” means alarm while the value
change from big to small.
 “A+B” to confirm and store setting and return to the menu item.
10. The direction of second alarm point
Press button “A”, unit is displayed. Other is the same as step 9.
11. The Delay
Press button “A”, unit is displayed.
 “A+B” menu item for setting.