ABtUS AB21234458 - Manual (Page 5)

User Operation Guide
Make the adhesive band wider by applying a second
strip next to the first strip. If you have enough tape, stick
a third strip above the others. If you still have tape, stick
a third strip on the bottom as well. (see illustration).
Check: Turn the projector on. The distance between the
illuminated image and the tape must be exactly 5 cm / 2”
(if you have the AB2123208 product) or exactly 7 cm / 2.8”
(if you have the AB2123308 product). (see illustration).
Turn the projector off again.
2: Stir the mixture of ContrastBooster and BaseCoat
with a new stir stick for at least 3 minutes until the
color of the mixture is uniform. Afterwards close the
bottle tightly and shake it well. Then pour the mixture
in a completely clean roller pan (see illustration).
3: Attach one of the two large roller covers (length
15 cm / 6”) to the roller. Make sure the roller is
completely covered with BaseCoat and roll it over
the surface of the roller pan to distribute the paint evenly.
Special note!!! Apply the layer of BaseCoat on the
inside and about 15 cm away from the tape on top of
the magnetic paint (see illustration).
Roll the paint out smoothly towards the center of the
projection screen so that no edges are created. Let
this layer dry for at least 60 minutes.
4. Apply a second layer of BaseCoat on top of the magnetic paint in the same way and let this
layer dry for at least 60 minutes as well.
During drying, place the roller in the roller pan and make sure that it is covered with sufficient
paint to prevent it from drying out.
5: Apply the BaseCoat in an even layer over the entire screen
surface, that means the entire area between the tape strips.
Apply the layer as follows: Start in the upper lefthand corner.
Paint a strip that is about 50 cm wide. Apply the paint evenly.
Always start with horizontal strokes (see illustration a) and
then roll the paint on in vertical strokes without stopping in the
middle of a strip (see illustration b).
Always roll the paint on with even and smooth movements.
Then continue by painting a second strip of about 50 cm. Make
sure that there is a slight overlap with the first strip
(see illustration c).
Always apply the paint fully “wet on wet”. For larger areas (for
example, an entire wall), make sure you have a long enough
handle on your roller.
Repeat this until the screen area is completely painted.
Let this layer dry for at least 60 minutes. During drying, place
the roller in the roller pan and make sure that it is covered with
sufficient paint to prevent it from drying out.
6: Apply a second layer of BaseCoat
over the entire area in the same
way. As you do so, pay attention to
the following:
Never go over an area that’s
already been painted a second time
with the roller.
Let this layer dry for at least 120 minutes.
Remove the roller cover and clean the roller thoroughly.
Remove the rest of the paint from the roller pan and clean it completely.
Important: Make sure that absolutely no residue of paint remains in the roller pan!!!
Paint particles can cause problems in applying the top layer (TopCoat).
7: If you see any uneven spots on the second basis layer, sand very lightly and very very
carefully until they disappear.
Remove the roller from the wall only when it reaches the tape strip. Do not remove the roller
from the wall if it is still on the screen (this can leave behind a visible mark). (see illustration).
-
-
Tips
if you turn the projector on you can
easily see any irregularities or bad
spots.
(Be careful not to sand too deeply or you will expose
the magnetic layer (“MagneCoat”) and/or make the
basis layer visible!). Leave the tape on the wall. Use
a rag or soft brush te remove dust from the surface.
**Specification are subjected to changes without notice...for detail and updated information please visit www.abtussinagpore.com 09 08