ABtUS AVS-SCL402/A - Manual (Page 4)

User Operation Guide
* Specifications are subject to changes without notice.
4. Sharpness
Change the picture
sharpness
3. Saturation
Change picture color, to
make it more colorful or
faded
12. Output Mode
Change and selection of
Output resolution setting
9. Blue back ground
When there is no signal
input, the back ground
setting is blue in color
10. Self pattern out
Output a while page for
turning of screen. (it is
recommended to use this
setting when auto adjust
doesn’t work and there is
a b n o r m a l w i t h t h e
screen)
13. Exit
Leaving the OSD menu
7. Setting:
Enter other setting menu 8. Recall color
Recall current source
Contrast, Brightness,
Saturation, Sharpness.
Noise reduce and Hue
to factory setting
5. Noise reduce
Reduce the interference.
The higher the setting the
less interference you will
get, but it could cause
picture distortion, so it is
advices that the user
should change the setting
to own preference.
6. Hue
Changing picture Hue.
Increasing the Hue will
make the picture red
while decreasing the
Hue will make the
picture green.
11. Information
Display current signal input
source, input format and
out resolution.
14. Volume
When OSD menu is closed, use
the “t” and “u” on the front panel
to control the volume level
04 05