ABtUS AV508-S - Manual (Page 2)

*Specifi cations are subject to changes without notice.
User Operation Guide
About 5-6mm
away from hole
PACKAGE CONTENTS
INSTALLATION
INSTALLATION
Item 1
Wall Arm - 1 set Item 2
Screw bag - 1 set Item 3
Covers - 2 pcs
LCD TV
UP
Step - 2 — Fix 2x screws onto back of LCD TV
(in up-right position) at the upper set of holes.
Leave screws about 5-6mm away from holes.
*NOTE: if screws provided can’t fi t, please refer to
the Plasma TV user manual for the correct
mounting thread screw size.
Step - 1— Marks position of the Wall Plate mounting holes.
1(a) - For concrete wall, drill and insert Wall Anchors (in Item 2) into concrete wall. Secure Wall
Arm (Item-1) with Lag bolts and Washers provided on the wall.
1(b) - For wood stud, drill and secure Wall Arm (Item-1) with Lag bolts and Washers provided
on wooden wall.
Note: do not use Wall Anchor for mounting on wooden wall.
1(c) - cover the screws with the Covers (Item-3)
Step - 3 -Lift and insert LCD TV with screws through the “key” holes on the front plate of the Wall Arm
mounted on the wall done in Step-1. Secure with 2x screws at the bottom of the front plate. Tighten all
screws.
Hammer
Gently
Push in
Wall anchors
Lag Bolts
and Washers
Wall Stud
Cover
1(a) - for concrete wall 1(b) - for stud wall
NOTE: Do consult a qualifi ed and authorized service technician if you encounter any technical
diffi culties. We are not liable for any damage or injuries arising from any improper installation or
mishandling.
5(b) - Leveling
5(a) - Tilting
5(a) - Loosen
2x screws
5(b) - Loosen
2x screws
End caps Side covers
Cables
Secure screws
“key” hole
Front plate
LCD TV
Step - 4 - For Cable management, remove
the End caps and slide the Side covers out
of the arms. Run cables in the space of the
arm. When done, Side covers can be slide
back or clip from the front until hear a “click”
sound. Cover back the End caps.
Step - 5— Adjustment:
5(a) Tilting—loosen the bottom screws at
curved slot hole area, grasp the upper and
lower edges of the Plasma, pull or push the
Plasma to tilt it to a desired viewing angle.
Tighten all screws.
5(b) Leveling — loosen screws as shown.
Grasp the left and right edges of the Plasma,
roll up or down to level the Plasma.