ABtUS AV545-W - Manual (Page 2)

User Operation Guide
1). Do not over tighten screws during installation. Over tightening can cause damage to the
screws and greatly reduce their ability to support the weight of the display.
2). Ensure that the mounting screws are anchored to the center of studs. Use of
an “edge to edge” stude finder is highly recommended.
INSTALLATION
Step 2:
Mount the TV set onto the TV board using A-F bolt packed in
accessories package. Fix the screw (A-F) and Spacer (I) to the TV
set mounting holes as shown in above flg.
Step 3: Putting the wall mounted TV board with screen
to the wall board
Hand the TV set mounted on the TV board (L) to the wall
board (M). Finally, put the locking bar into the matched hole.
Step 1: Mounting the wall board to the studs
Drill holes onto the wall and put 10x40 Concrete
anchor (H) in the holes. Fit the wall board to the wall
using ST8x50 Lag bolt (G) and 08.5x18x1.5 Spacer
(J) as shown above / right fig.
Keep the bubble level aline.
PACKAGING CONTENT
Item
L TV Board 2 sets
Item
M Wall Board 1 set
* Specifications are subject to changes without notice. ** For detail, updated Command Code and Application Software, please visit and download from www.abtussingapore.com
Item
K 08.5x18x1.5 Washer 4 sets
Item
A Bolt M5x16 4 sets
B Bolt M5x30 4 sets
C Bolt M6x16 4 sets
D Bolt M6x30 4 sets
E Bolt M8x16 4 sets
F Bolt M8x30 4 sets
Item
I Spacer with 3 holes 4 sets
Item
J 08.5x18x1.5 Spacer 4 sets
Item
G Lag bolt St8x50 4 sets
Item
H Concrete anchor 10x40 4 sets
A to F