Draper FlatScreen Lift FSL-F-42 - Manual (Page 3)

Dimensions
Dimensions—with Extensions
Caution: Do not obstruct operation of lift with fi ngers or any
object. Serious injury or damage could result.
B
20 1 / 2 "
32"
17"
3
1 /
4 "
3
1 /
16 "
15 /
16 "
2
3 /
16 "
20"
8
13
/
16
"
A
Model Dim A Dim B
FSL-F-42 25 13 /
16
" 42"
FSL-F-50 29 3 /
4
" 46 1 /
16
"
FSL-F-65 35 1 /
4
" 63"
Model Dim C Dim D
FSL-F-42 59 1 /
4
" 25 3 /
8
"
FSL-F-50 73 1 /
2
" 29"
FSL-F-65 83 5 /
8
" 30 9 /
16
"
C
D
Flatscreens Lift by Draper, Inc.
page 3 of 7
www.draperinc.com (765) 987-7999
Attaching the FSL Universal TV Mount Kit
Connect the mount plate and lift bracket
➀ Find the M6 x 12 screws with washer and nut in the screw pack.
➁ With the help of an assistant, position the mount plate level against the lift
in the desired mounting location.
➂ Mark the right (upper and lower) and the left (upper and lower) positions of
the small horizontal slots that are in alignment with vertical slot on the
metal studs of the lift.
➃ With the help of an assistant, position the mounting plate against the lift
and line up the mounting slots.
➄ For each location, insert a screw, washer and nut with lift bracket.
➅ Tighten each screw with an open ended socket wrench by turning
clockwise until tight.
Display bracket installation
➀ To ensure optimal installation, this kit includes various screws of different
diameters and lengths.
➁ Place your TV screen down on a soft, fl at surface, and locate the threaded
mounting points that are located on the back of the display.
➂ Determine which screw is the correct length by carefully inserting a straw,
or toothpick, and mark how deep the mounting point is.
➃ If your display has a curved back or a recessed thread mounting point, a
spacer must be used.
➄ Place the spacer between the mounting bracket and the display.
➅ If a smaller screw is being used, please use a washer with each screw for
added
stability.
Final installation
➀ Attach each bracket to the display by aligning the holes on each bracket,
with the thread insert on the back panel of your display, inserting the
screws through both and turning clockwise until they are fully inserted.
➁ Tighten with a Phillips head screw driver.
➂ To complete the installation of your new plasma mount, carefully place the
television brackets over the upper and lower mounting lips.
➃ Insert the locking rods to secure the mounting bracket.