Dimplex DFI2309 User Manual

Page 13

DFI2309

If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.

Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.

TO REPLACE FLAME MOTOR/FLAME ROD

1. Remove the trim and firebox from mantel.

2. Remove the trim from firebox.

3. Remove the (2) outer screws from the log grate.

4. Slide the light assembly out of the insert by pulling and lifting up on the log grate until

the light assembly comes out of the unit.

5. Remove the (2) flame motor cover screws and set aside.

6. Remove the (3) flame motor wires (black, white, and brown) from the terminal block.

NOTE: A small Philips head screwdriver is required.

7. Remove the (2) flame motor mounting screws.

8. Remove flame rod from flame motor by pulling the rubber channel section of the

flame rod away from flame motor.

9. Reassemble in the reverse order as above.