Directed Electronics 1100d - Manual (Page 7)

7
© 2002 Directed Electronics, Inc
1. RRCCAA IInnppuutt JJaacckkss - Accepts line level
outputs from head units or signal
processors at voltages between
150mV and 8 volts.
2. RRCCAA SSyynncc OOuutt// SSllaavvee IInn JJaacckk
Sync Out - This RCA jack sends a
Synced or in-phase gain matched
output signal to a slave amplifier
when connected in the Parallel
Synced Gain combination. It is a
Synced output when the
slave/master switch is in the
MASTER position only.
Slave In - This RCA jack accepts
input from a master amplifier. It is
for use in the Parallel Synced Gain
and External Synced Bridged combi-
nations. It is a slave input when the
slave/master control switch is in
the SLAVE position only.
3. RRCCAA BBrriiddggee OOuuttppuutt JJaacckk - This output
sends an out-of-phase signal to a
slave amplifier when connected in
the External Synced Bridged combi-
nation. (Refer to the
Combined
Amplifiers section of this guide)
4. SSllaavvee//M Maasstteerr SSw wiittcchh - Controls
whether the amplifier is a slave or
master when connected in
combined amplifier configurations.
(Refer to the
Combined Amplifiers
section of this guide.)
5. RReem moottee SSuubb LLeevveell CCoonnttrrooll - Controls
the subwoofer amplifier gain
controls from a remote location for
ease of adjustment during listening.
W Waarrnniinngg:: DO NOT connect a level control knob from other
manufacturers to the Remote Sub Level Control of
any Directed amplifier. Even though the connectors
fit properly, the control knob and connector pin
positions may be different and the amplifier will be
damaged.
FRONT PANEL CONNECTIONS
INPUT I/O
R
L
SLAVE MASTER
REMOTE
SLAVE IN
SYNC OUT
BRIDGE OUT
FIGURE 1—AMPLIFIER CONNECTIONS 600d/1100d FRONT
3 1 4 5 2