MIPRO mr801(2ce126)a2 - Manual (Page 3)

(Fig.6)
(Fig.7)
- 4 - - 3 -
3. Rack Mounting
1. Single half-rack receiver
(a) Push the rack mount ear optional accessory (FB-11) upwards
until it is firmly attached to the receiver. (fig. 6)
2. Dual half-rack receivers
(a) Position theconnecting plates between the top andbottom of the
two receivers and tighten. (Fig.7)
(b)After joining the 2 receivers together, push the optional accessory
rack mount ears (FB-12) upwards until they firmly attached to the
receiver. (Fig. 7)
2. Installation Of The Receiver
UNBALANCEDOUT
A N T . B
BALANCEDOUT LINE
LEVEL
MIC
S Q
ANT.A
1. Install antenna in rear (8)(13) or at the front (1)(5). E xtend antenna
to the fullest position. see fig. 3.
2. Power Output Connection:
(a) Connect the AC/DC adapter cable to DC 12V INPUT JACK (7),
then plug the adapter unit into an appropriate AC outlet with
caution to the correct voltage under both AC outlet and adapter
marked, as shown in fig. 4.
(b) With the appropriate AC power cable connects from AC Input
Jack (6) to an AC outlet under the marked voltage 85~265 V, as
shown in fig. 5.
3. Audio Output Connection:
(a) Unbalanced Level Switch (11) Setting Position: When inputs the
unbalanced output of a receiver into "Line-in" input jack of a
mixer or amplifier or "ElectricGuitar", switch the Level Switch ( 11)
to the right "LINE" position. Low sensitivity may occur if switch
to the wrong position. When input the unbalanced output of a
receiver into the "MIC-IN" input jack of a mixer or amplifier;
switch the Level Switch (11) to the left "MIC" position. Over load
distortion m a y occur if switch to the wrong position. When using
electric guitar, don't use "MIC" position as it may have
generated insufficient level.
(Fig.3)
(Fig.4)
A N T . B + -
(Fig.5)
A N T . B
POWER
TRUEDIVERSITYWIRELESSRECEIVER
MR-801 SIGNAL AUDIO POWER
TRUEDIVERSITYWIRELESSRECEIVER
MR-801 SIGNAL AUDIO
POWER
TRUEDIVERSITYWIRELESSRECEIVER
MR-801 SIGNAL AUDIO POWER
TRUEDIVERSITYWIRELESSRECEIVER
MR-801 SIGNAL AUDIO