MIPRO act707d(2ce150)b - Manual (Page 3)

2 3
ACT DUAL CHANNEL WIRELESS RECEIVER ACT DUAL CHANNEL WIRELESS RECEIVER
2. PARTS NAME AND FUNCTIONS
Front Panel：
Rear Panel：
(Fig.1)
(Fig.2)
(1) Front Antenna A Input Connector : A llows an optional rear-to-front
Antenna kit for front antenna placement.
(2) Power Switch & Indicator: When switch is turned on, red indicator
illuminates to denote normal power status.
(3) Receiver Panel A : Color LCD Panel A.
(4) Receiver Panel B : Color LCD Panel B.
(5) Front Antenna B Input Connector : Allows anoptional rear-to-front
Antenna kit for front antenna placement.
(6) Antenna B input Connector: Antenna B connector can be installed with
antennadirectly and provides power for antenna booster.
(7)(10) Balanced Audio Output Jack: WithCannon / XLR type connector
providesbalanced audio output signal that matches capsule sensitivity.
(8) Unbalanced Audio Mixed Output Jack : With 1/ 4 Phone Jack
provides the mixed unbalanced audio output signal from this jack to the
amplifier.
(9) Unbalanced Level Switch: "MIC" selection is for "Microphone-level"
output. "LINE" selection is for "Line-out" level output.
(11) Computer Network Interface Connector: Network socket to connect to
the computerized system-monitoring program.
(12) AC Input Jack: To connect 85 ~ 265 Volts AC power.
(13) AntennaA input Connector: Antenna A connector can be installed with
antennadirectly and provides power for antenna booster.
(14) Rackmount Bracket: To install the receiver into an EIA 19-inch standard
rack case.
λ
13 14
3:COLD - 1:GND + 2:HOT 3 2 1
MADEINTAIWAN LEVEL M I X O U T B A L A N C E D O U T B A N T E N N A A
AC100V~240V
MIC LINE
+8VDCBIAS +8VDCBIAS
ANTENNAB
REMOTE
I N OUT
B A L A N C E D O U T A
7 8 9 10 11 6 12
2 3 4
ACT-707D WirelessReceiver
ON
POWER
A B
1 5
R F A F
M H z
G / C H V O L FREQ SQ R E M O N A M E
B A T ANT B A RF A F
MHz
G / C H VOL FREQ S Q REMO NAME
BAT A N T B A
ACT
MENU
G R O U P
SCAN
ACT
M E N U
GROUP
SCAN