Troubleshooting – Optoma WHD200 User Manual
Page 22
22
4.
Troubleshooting
Problem
Solution
The WHD200 power
indicator LED doesn't
light up.
Check if the power plugs of WHD200T/WHD200R are properly
inserted into a functioning power outlet.
No video is displayed
on your TV screen.
Verify that the proper cables have been selected and installed
between the WHD200T (transmitter) input and your High-Definition
device output.
On your TV side (connected to the WHD200R), select the HDMI as
input source.
Verify the POWER LED and SOURCE LED indicator of WHD200.
Power LED Flashing in Blue
OSD displayed:
(4 levels looping)
* Ensure the transmission range between the transmitter and the
receiver is NOT over 66 feet (LOS-line of sight) transmission distance.
* Try to move the transmitter closer to the receiver.
POWER LED in Solid Blue + Slow and Flashing SOURCE LED
OSD displayed :
* Ensure your video resolution and frame rate is recognized/ supported
and within the transmission range.
*Connect the source device to your TV to check and modify the video
format compatibility.
*Check if your video resolution with HDMI input from your device is set
among 1080p, 1080i, 720p, 576p, or 480p. Please refer Chapter 5 for
the detail supported Resolution.
POWER LED in Solid Blue STATUS LED Flash Quickly
OSD displayed :
* Ensure the proper cables are connected between the transmitter and