Optoma OWM855W - Manual

Attach Wall Plate To Wall 1
Secure Boom Arm To Wall Plate 2
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLING YOUR EQUIPMENT.
INSTALL THE MOUNT IN A SUITABLE LOCATION USING FIXINGS WHICH ARE APPROPRIATE FOR THE WALL
MATERIAL AND STRUCTURE. CONSULT A QUALIFIED BUILDER IF YOU ARE IN ANY DOUBT AS TO THE
STRUCTURAL INTEGRITY OF THE WALL.
USE ALL AVAILABLE FIXING POINTS.
DO NOT ATTEMPT TO ALTER OR MODIFY ANY PART OF THE WALL MOUNT OR IT'S ATTACHMENTS.
DO NOT USE IF ANY PARTS ARE BROKEN OR APPEAR TO BE DAMAGED.
TIGHTEN ALL BOLTS AND FIXINGS SECURELY. ONLY USE FIXINGS PROVIDED WITH THIS BRACKET.
DO NOT MOUNT YOUR PROJECTOR NEAR TO SOURCES OF HEAT OR MOISTURE.
ALWAYS HAVE A MINIMUM OF TWO PERSONS TO INSTALL THE PROJECTOR AND THE MOUNT.
1
NOTE:
Ÿ Attach boom arm to wall plate at
required height.
Ÿ To adjust height once the mount is
installed refer to Stage 6
CAUTION NOTE!
This mount is designed to take projectors up to a
weight of 15Kgs. For safety reasons the mount
has been tested with a dead weight loading of
75Kgs. It is recommended that if the installation is
at risk of being subjected to greater loads then
you should additionally tether the mount to the
ceiling using the tether point (highlighted below).
The tether point uses an M6 thread which can
accept any M6 fixing such as an eye bolt or hook.
a b
Ax4
Bx4
Tether Point
MOUNTING INSTRUCTIONS FOR
SHORT THROW PROJECTOR MOUNT
MODEL No. OWM855/OWM855W
FN. OWM855/OWM855W
Max Weight Loading 15Kgs
Projector Mount Assembly Kit
C - M6 x 12mm
x2
A - M8 x 16mm
B - M8 / M6
x4
x4/x3
NOTE: Refer to supplied drilling template
for mounting Optoma 610ST, 605ST, 210ST,
X305ST, W305ST, X306ST & W306ST Models
Ÿ For ease of installation mount bracket on wall using position 1
and mark other positions using a spirit level. Then remove
fixing from position 1, remove bracket and drill other positions
Ÿ Use Fixings suitable for your type of wall construction.
Ÿ Use All available fixing points.
Ÿ If in any doubt of the suitability of the wall, it's construction or
what type of fixings to use, consult a qualified builder or installer.