Lamp settings, Optional filter settings – Optoma S313 User Manual
Page 45
EN-45
Power Mode (Standby)
Set whether the VGA-OUT function works when the projector is in standby
(powered off but connected to AC power).
Eco: The VGA-OUT function will not work when the projector is in
standby.
Active: The VGA-OUT and AUDIO-OUT functions will work when the
projector is in standby.
Note
When Power mode (Standby) is set to Eco (<0.5W), the VGA output, Audio pass-
through will be deactivated when the projector is in standby.
Lamp Settings
Lamp Hours
Display the projection time.
Lamp Reminder
Choose this function to show or to hide the warning message when the
changing lamp message is displayed.
Brightness Mode
Bright: Choose “Bright” to increase the brightness.
Eco.: Choose "Eco." to dim the projector lamp which will lower power
consumption and extend the lamp life.
Dynamic: Choose "Dynamic" to dim the lamp power which will be based
on brightness level of the content and adjust lamp power consumption
between 100% and 30% dynamically. The lamp life will be extended.
Eco+: Choose "Eco+." to dim the lamp power which will be based on
brightness level of the content and adjust lamp power consumption
between 80% and 30% dynamically. The lamp life will be extended.
Image Life
Choose "On" to turn on the image life. Choose "Off" to turn off the image life.
Lamp Reset
Reset the lamp hour counter after replacing the lamp.
Optional Filter Settings
Optional Filter Installed
Choose “Yes” if an optional dust filter is installed.
Filter Usage Hours
Display the dust filter’s elapsed operating time (in hours).