Connecting an, S-video source, Device” on – Optoma S313 User Manual

Page 22: Connecting a, Composite video, Source device” on, Connecting an s-video source device, Connecting a composite video source device

EN-22

Connecting an S-Video source device

Examine your Video source device to determine if it has an unused S-Video
output socket available:

If so, you can continue with this procedure.

If not, you will need to reassess which method you can use to connect to

the device.

To connect the projector to an S-Video source device:
1. Take an S-Video cable and connect one end to the S-Video output

socket of the Video source device.

2. Connect the other end of the S-Video cable to the S-VIDEO socket on the

projector.

Important

If the selected video image is not displayed after the projector is turned on and

the correct video source has been selected, check that the Video source

device is turned on and operating correctly. Also check that the signal cables

have been connected correctly.

If you have already made a Component Video connection between the

projector and this S-Video source device using Component Video connections,

you need not connect to this device using an S-Video connection as this

makes an unnecessary second connection of poorer picture quality. See

for details.

Connecting a composite Video source device

Examine your Video source device to determine if it has a set of unused
composite Video output sockets available:

If so, you can continue with this procedure.

If not, you will need to reassess which method you can use to connect to

the device.

To connect the projector to a composite Video source device:
1. Take a Video cable and connect one end to the composite Video output

socket of the Video source device.

2. Connect the other end of the Video cable to the VIDEO socket on the