NISSAN 2009 Rogue - Manual (Page 117)

Black plate (115,1)
Model "S35-D" EDITED: 2008/ 7/ 24
to three times to complete the training.
8. Your HomeLink ® button should now be
programmed. To program the remaining
HomeLink
® buttons for additional door or
gate openers, follow steps 2 through 8 only.
NOTE:
Do not repeat step 1 unless you want to
“clear” all previously programmed Home-
Link
® buttons.
If you have any questions or are having difficulty
programming your HomeLink
® buttons, please
refer to the HomeLink ® web site at: www.
homelink.com or call 1-800-355-3515.
PROGRAMMING HomeLink ® FOR CA-
NADIAN CUSTOMERS
Prior to 1992, D.O.C. regulations required
hand-held transmitters to stop transmitting after
2 seconds. To program your hand-held trans-
mitter to HomeLink
® , continue to push and hold
the HomeLink ® button (note steps 2 through 4
under “Programming HomeLink ® ”) while you
push and re-push (“cycle”) your hand-held
transmitter every 2 seconds until the indicator
light flashes rapidly (indicating successful pro-
gramming).
NOTE:
If programming a garage door opener, etc.,
it is advised to unplug the device during
the “cycling” process to prevent possible
damage to the garage door opener com-
ponents.
OPERATING THE HomeLink ® UNIVER-
SAL TRANSCEIVER
HomeLink ® Universal Transceiver (once pro-
grammed) may now be used to activate the
garage door, etc. To operate, simply push the
appropriate programmed HomeLink
® Universal
Transceiver button. The red indicator light will
illuminate while the signal is being transmitted.
PROGRAMMING TROUBLE-DIAGNO-
SIS
If HomeLink ® does not quickly learn the hand-
held transmitter information:
. replace the hand-held transmitter batteries
with new batteries.
. position the hand-held transmitter with its
battery area facing away from the Home-
Link
® surface.
. push and hold both the HomeLink ® and
hand-held transmitter buttons without inter-
ruption.
. position the hand-held transmitter 2 to 5 in
(50 to 127 mm) away from the HomeLink ®
surface. Hold the transmitter in that position
for up to 15 seconds. If HomeLink
® is not
programmed within that time, try holding the
transmitter in another position - keeping the
indicator light in view at all times.
If you continue to have programming difficulties,
please contact the NISSAN Consumer Affairs
Department. The phone numbers are located in
the Foreword of this Owner’s Manual.
CLEARING THE PROGRAMMED IN-
FORMATION
Individual buttons cannot be cleared, however to
clear all programming, push and hold the two
outside buttons and release when the indicator
light begins to flash (in approximately 20
seconds).
REPROGRAMMING A SINGLE
HomeLink
® BUTTON
To reprogram a HomeLink ® Universal Transcei-
ver button, complete the following.
1. Push and hold the desired HomeLink ®
button. Do not release the button until step
4 has been completed.
2. When the indicator light begins to flash
slowly (after 20 seconds), position the
hand-held transmitter 2 to 5 in (50 to 127
mm) away from the HomeLink
® surface.
3. Push and hold the hand-held transmitter
button.
Instruments and controls 2-49