NISSAN 2009 Rogue User Manual

Page 116

Black plate (114,1)

Model "S35-D" EDITED: 2008/ 7/ 24

SIC3182

1. To begin, push and hold the 2 outer Home-

Link

buttons (to clear the memory) until the

indicator light

blinks (after 20 seconds).

Release both buttons.

2. Position the end of the hand-held transmitter

1-3 inches away from the HomeLink

sur-

face.

SIC3183

3. Using both hands, simultaneously push and

hold both the HomeLink

button you want to

program and the hand-held transmitter
button.
DO NOT release the buttons until step 4 has
been completed.

4. Hold down both buttons until the indicator

light on HomeLink

flashes, changing from a

“slow blink” to a “rapid blink”. This could
take up to 90 seconds. When the indicator
light blinks rapidly, both buttons may be
released. The rapidly flashing light indicates
successful programming. To activate the
garage door or other programmed device,
push and hold the programmed HomeLink

button - releasing when the device begins to

activate.

5. If the indicator light on HomeLink

blinks

rapidly for two seconds and then turns solid,
HomeLink

has picked up a “rolling code”

garage door opener signal. You will need to
proceed with the next steps to train Home-
Link

, completing the programming may

require a ladder and another person for
convenience.

6. Push and release the program button

located on the garage door opener’s motor
to activate the “training mode”. This button is
usually located near the antenna wire that
hangs down from the motor. If the wire
originates from under a light lens, you will
need to remove the lens to access the
training button.

NOTE:
Once you have pushed and released the
training button on the garage door open-
er’s motor and the “training light” is lit, you
have 30 seconds in which to perform step
7. For convenience, use the help of a
second person to assist when performing
this step.

7. Quickly (within 30 seconds of pushing and

releasing the garage door opener training
button) and firmly push and release the
HomeLink

button you’ve just programmed.

Push and release the HomeLink

button up

2-48

Instruments and controls