Subaru 2011 Impreza WRX - Manual (Page 127)

Black plate (129,1)
北米Model "A1110BE-C" EDITED: 2010/ 12/ 17
: Deactivated
NOTE
. Your vehicle’s initial movement
setting of the meter/gauge needles
has been set for activation
“ ” at the
time of shipment from the factory.
. It is not possible to cancel the initial
movement setting of the meter/gauge
needles when the ignition switch is in
the
“ON” position. Cancel the setting
when the ignition switch is in the
“LOCK” or “Acc” position.
& Meter/Gauge needle illumi-
nation setting (turbo models
except STI)
When the setting is activated or deacti-
vated, the meter needles and gauge
needles illuminate and turn off as follows.
Activated:
When the driver
’s door is opened while
the ignition switch is in the “LOCK”
position, the needles illuminate and turn
off after approximately 20 seconds. The
illumination of the needles gradually turns
off after the ignition switch is turned from
the
“ON” position to the “LOCK” position.
Deactivated:
The needles do not illuminate when the
driver
’s door is opened while the ignition
switch is in the “LOCK” position. The
illumination of the needles turns off im-
mediately after the ignition switch is turned
from the
“ON” position to the “LOCK”
position.
NOTE
. Even during the illumination after
the driver
’s door is opened, if the
ignition switch is turned to the “ON”
position, the combination meter will
illuminate as usual.
. If the doors are locked by the remote
keyless entry system during the illumi-
nation after the driver
’s door is opened,
the illumination will be turned off.
. Even while the illumination gradu-
ally turns off after the ignition switch is
turned to the
“LOCK” position, if the
ignition switch is turned to the “ON”
position, the combination meter illumi-
nate as usual.
To change the setting:
1. Turn the ignition switch to the
“LOCK”
or “Acc” position.
2. Press the trip knob to show “ ” or
“ ” on the odometer and trip meter
display. The display can be switched as
shown in the following illustration by
pressing the trip knob.
*: “ ” or “ ”, and “ ” or “ ” cannot
Instruments and controls
3-7
– CONTINUED –
3