Mercedes-Benz 2012 B Class - Manual (Page 266)

X Push a round pen into opening
=(
Y page 263) for approximately three
seconds.
The zone currently selected appears in
compass display ;(
Y page 263).
X To select the zone: push a round pen into
opening =( Y page 263) until the desired
zone is selected.
If, after a few seconds, the display in
compass display ;(
Y page 263) changes
direction, the zone has been selected.
Calibrating the compass
X Make sure that there is sufficient space for
you to drive in a circle without impeding
traffic.
In order to calibrate the compass correctly,
do the following:
R
calibrate the compass in the open and not
in the vicinity of steel structures or high-
voltage transmission lines.
R
switch off electrical consumers such as the
climate control, windshield wipers or rear
window defroster.
R
close all doors and the tailgate.
X Switch on the ignition.
X Push a round pen into opening
=(
Y page 263) for approximately six
seconds, until symbol C is shown in
compass display ;( Y page 263).
X Drive your vehicle in a full circle at
approximately 3 mph (5 km/h) to 6 mph
(10 km/h).
When the calibration has successfully been
completed, the current direction is shown
in compass display ;(
Y page 263).
Floormat on the driver's side
G
WARNING
Objects in the driver's footwell can restrict the
pedal travel or obstruct a depressed pedal.
The operating and road safety of the vehicle
is jeopardized. There is a risk of an accident.
Make sure that all objects in the vehicle are
stowed correctly, and that they cannot enter
the driver's footwell. Install the floormats
securely and as specified in order to ensure
sufficient clearance for the pedals. Do not use
loose floormats.
X Slide the seat backwards.
X To install: place the floormat in the
footwell.
X Press safety catch knobs : onto
retainers ;.
X To remove: pull the floormat off
retainers ;.
X Remove the floormat.
264
Features
Stowage and features