Towing the vehicle with the rear axle raised, Towing a vehicle with both axles on the ground, Transporting the vehicle – Mercedes-Benz 2013 M Class User Manual
Page 395: Breakdown assistance, Towing and tow-starting

Removing the towing eye
X
Loosen the towing eye and unscrew it.
X
Attach cover : or ; to the bumper and
press until it engages.
X
Place the towing eye in the vehicle tool kit.
Towing the vehicle with the rear axle
raised
!
The ignition must be switched off if you
are towing the vehicle with the rear axle
raised. Intervention by ESP
®
could
otherwise damage the brake system.
Only possible for vehicles without
4MATIC.
X
Switch on the hazard warning lamps
(
X
Turn the SmartKey to position
0 in the
ignition lock and remove the SmartKey
from the ignition lock.
X
When leaving the vehicle, take the
SmartKey or the KEYLESS-GO key with you.
When towing your vehicle with the rear axle
raised, it is important that you observe the
safety instructions (
Towing a vehicle with both axles on
the ground
It is important that you observe the safety
instructions when towing away your vehicle
(
The automatic transmission automatically
shifts to position
P when you open the driver's
or front-passenger door or when you remove
the SmartKey from the ignition lock.
In order to ensure that the automatic
transmission stays in position
N when towing
the vehicle, you must observe the following
points:
X
Make sure that the vehicle is stationary and
the SmartKey in the ignition lock is in
position
0.
X
Turn the SmartKey to position
2 in the
ignition lock.
On vehicles with KEYLESS-GO, use the
SmartKey instead of the Start/Stop button
(
X
Depress and hold the brake pedal.
X
Shift the automatic transmission to
position
N.
X
Release the brake pedal.
X
Release the electric parking brake.
X
Leave the SmartKey in position
2 in the
ignition lock.
X
Switch on the hazard warning lamps
(
i
In order to signal a change of direction
when towing the vehicle with the hazard
warning lamps switched on, use the
combination switch as usual. In this case,
only the indicator lamps for the direction of
travel flash. After resetting the
combination switch, the hazard warning
lamp starts flashing again.
Transporting the vehicle
!
Only lash the vehicle down by the wheels
or wheel rims, not by parts of the vehicle
such as axle or steering components.
Otherwise, the vehicle could be damaged.
The towing eyes or trailer tow hitch can be
used to pull the vehicle onto a trailer or
transporter if you wish to transport it.
X
Turn the SmartKey to position
2 in the
ignition lock.
X
Shift the automatic transmission to
position
N.
Towing and tow-starting
393
Breakdown assistance
Z