Saab 2006 9-7X - Manual (Page 141)

To turn the rear wiper on, turn the control to either 1, 2,
or 3. For delayed wiping, turn the control to 1 or 2.
For steady wiping, turn the control to 3. To turn the
wiper off, turn the control to 0.
To wash the rear window, press the washer symbol
located in the center of the control.
The rear window washer uses the same fluid bottle as
the windshield washer. However, the rear window
washer will run out of fluid before the windshield washer.
If you can wash your windshield but not your rear
window, check the fluid level.
Headlamp Washer
Your vehicle may be equipped with a headlamp washer
system. The headlamp washers clear debris from the
headlamp lenses by soaking the lens with fluid, waiting
for about five seconds, then rinsing the loose debris
from the lenses.
The headlamp washers are located under the
headlamps. The headlamp washers activate for one
wash-wait-rinse cycle when the front windshield washer
button is pressed for the first time after your vehicle
is turned on. The headlamps washers then activate
automatically for one cycle after every four front
windshield washes.
The headlamps must be on to be washed. If the
headlamps are off, only the front windshield will be
washed. See Windshield Washer on page 3-10 for
more information.
Cruise Control
9 (Off): This position
turns the system off.
R
(On): This position activates the system.
+ (Resume/Accelerate): Push the lever to this symbol
to make the vehicle accelerate or resume to a
previously set speed.
T
(Set): Press this button to set the speed.
3-11