Lenco EB-900 - Manual (Page 5)

6.
OK/ Directional buttons
-OK button- Press to confirm or cancel.
-Directional buttons –roll the button up/ down/ left/ right to move
the cursor
7,8. Previous/Next pg button – press to turn to the previous /next
page
9. Earphone jack
10. Mini USB jack – for data transfer and emergency charging
11. SD card slot – supports SD card
12. Built-in Speaker
Power On and Off the Reader
• Press and hold the [Power] button for 3 seconds to turn on/off the
reader.
• It may take a few moments for the reader to turn on and load the
content.
• If the reader does not turn on, charging is required.
Charging the Reader
• You need to charge the reader prior to using it for the first time or
when battery power is low.
• Please turn the reader to standby mode to shorten the charging
process.
• It will take about 6 hours to fully charge the reader in standby
mode (LCD screen turned off)
• You can also charge the reader by connecting the USB cable to a
PC. Upon successful connection to PC, press the OK button to
select “Power”. Charging through PC may not be able to fully
charge the reader due to the low output charging current from PC
USB port.
• When a DC /USB power cable is connected to the reader for
charging, the reader will enter standby mode after remaining idle
for 60 seconds. Press the [Power] button to wake up the reader.
• The battery status is displayed at the bottom left corner. The
remaining battery playback time is displayed right next to the
battery icon.
Getting Started 3