Lenco DVL-2455 - Manual (Page 7)

7
Functional parts
Top View of the TV
Front View of the TV
1. V- Button
2. V+ Button
3. CH- Button
4. CH+ Button
5. MENU Button
6. SOURCE Button
7. Standby Button
8. Open/Close
9. Play/Pause
10. Remote sensor
11. Power indicator
To turn the TV power ON
Put the TV set on the correct place, then connect the DC plug of the AC-DC adaptor
to the DC 12V socket at the back of the TV set. Connect the adaptor main cord to the
wall outlet ,then the LCD indicator lamp turns red/blue and the TV set is at Standby
mode. At Standby Mode, if Standby Button is pressed the power indicator will change
to blue. It takes a few seconds before the picture appears.
To turn the TV power OFF
Press the Standby Button to make the TV set in Standby Mode, then disconnect the
power plug from the wall outlet.
NOTE:
If TV is the selected input without signal received and NO operation is performed for
about 5 minutes continuously, the TV set will enter standby mode. For any inputs
other than TV, the TV set will not enter standby mode automatically without users
instruction. If you are not going to use this TV set for a long time, switch off the set
and disconnect the power plug from the wall outlet.