Lenco DVD-519 H - Manual (Page 22)

22
Mono / stereo sound
Press the L/R/LANG/MO/ST button on the remote control to switch between mono/stereo
sound.
Remark: This function is very useful when the stereo signal is bad, the sound will improve
when you switch to mono.
Other functions on the remote control
2 or 5.1 Channel downmix
During a 5.1 CH or DTS DVD playback press the 2/5.1CH button on the remote control to
select “downmix 5.1CH” for the optimal sound effect. For all other audio set this function to
“downmix” stereo for the optimal sound effect.
Note: in some modes this function is not available.
Setup button
Press this button to open the setup menu, see chapter advanced settings.
Reset button
When the unit is in DVD mode with the disc tray closed and no DVD inserted (no disc on
screen), press the reset button on the remote control to restore the factory settings.
Advanced speaker settings
Output channel level control
During playback of a DVD or audio file you can adjust the output of every speaker
individually with a range of -10 up to +10 of the master volume. It is also possible to adjust
the bass and treble output of the master volume. To adjust press the CH-LEVEL button on
the remote control. Use the volume button on the remote control to adjust the output level
FL: Front left speaker
FR: Front right speaker
CEN: Center speaker
SL: Rear left speaker
SR: Rear right speaker
SUB: Subwoofer
Bass: Master Bass output
Treble: Master treble output
2 or 5.1 Channel downmix
During a 5.1 CH or DTS DVD playback press the 2/5.1CH button on the remote control to
select “downmix 5.1CH” for the optimal sound effect. For all other audio set this function to
“downmix” stereo for the optimal sound effect.