Lenco DVD-519 H - Manual (Page 13)

13
Basic operation
Turning the unit on and off
To turn on the main power of the unit place the power switch (16) on the back side of the
unit in on position. The unit is now in standby mode.
The unit can be turned on in two ways:
Press the standby button on the remote control.
Press the standby button (1) on the unit.
While operating you can turn the unit into standby mode in two ways:
Press the standby button on the remote control.
Press the standby button (1) on the unit.
When the unit will not be used we recommend turning off the unit by pressing the power
switch (16) on the back side of the unit in off position.
Selecting the source (Disc, USB, AUX in, FM)
To select the desired source press:
DVD on the remote control to select disc mode
USB on the remote control to select USB mode
AUDIO on the remote control to select AUX in mode.
FM on the remote control to select FM mode.
Adjusting the master volume
The master volume can be adjusted in several ways:
Press the volume + button on the remote control to increase the volume.
Turn the volume knob (7) on the unit to the right to increase the volume.
Press the volume – button on the remote control to decrease the volume.
Turn the volume knob (7) on the unit to the left to decrease the volume.
The master volume can be switched off and on by pressing the mute button on the remote
control.
Note: See chapter “advanced speaker settings” about how to individually adjust the volume
per speaker.
Navigating through menu’s
Use the direction buttons on the remote control to navigate through the menus and
settings. Press the play/enter button on the remote control to enter / confirm the settings or
to select the items.
Entering digits
Use the numeric buttons on the remote control to enter digits if needed. Press the clear
button on the remote control to clear the input field.
Use the 10+ key on the remote control to enter digits that are higher than 9.
For example: To enter 25; press 10+ twice and 5 once .