Lenco DVD-519 H - Manual (Page 21)

21
Listening to music during photo playback (USB mode only)
It is possible to listen to music during JPEG files playback. To do this, connect a USB device
that contains both JPEG as music files. When the automatic playback starts press the menu
button on the remote control to open the root menu. In the root menu use the direction
buttons on the remote control to go to the audio tracks and start playback by pressing the
enter button on the remote control. Now go to the desired JPEG file and open it by pressing
enter on the remote control. The slideshow will now start.
AUX In mode
Use this connection to connect the home theatre system to an analogue output of any other
device. See chapter advanced connection for information about how to connect an external
audio device.
Turn the unit on
1. Press the audio button on the remote control to enter aux in mode.
The unit will now output the audio of the external audio device over the speakers.
Note: In aux in mode it is only possible to adjust the volume.
FM Mode
Turn the unit on
1. Press the FM button on the remote control to enter FM mode.
Automatic search
Press the menu/search button on the remote control to auto-scan and auto-save all the
available channels.
Jump to frequency
To jump to a frequency press the T/F button on the remote control and then enter the
desired frequency.
Fine-tuning the frequency
Press the fast forward button on the remote control to go up to a higher frequency with 0.05
Mhz.
Press the fast backward button on the remote control to go down to a lower frequency with
0.05 Mhz.
Save frequencies
Tune to the frequency which needs to be saved and enter the number where the frequency
needs to be saved (for example 25), now press subtitle/save on the remote control to save
the frequency.
Switch between saved frequencies
Press the next button on the remote control to go one saved frequency up.
Press the previous button on the remote control to go one saved frequency down.