Digimate LTV-2007 - Manual (Page 11)

10
Power Connection
Connect the AC power cord to the LCD-Display and plug into an appropriate wall
outlet.
!
Note:
AC power Input : Connect power cord to this port
Your LCD Television can connect to a PC through the VGA connector. Check your PC’s
user’s manual to see which connectors are available on your PC.
1. Connect one end of the VGA cable to this monitor.
2. Connect the other end to your PC and tighten the securing screws on the connectors.
3. Connect one end of the PC-audio-in cable to Audio-in.
◇
Turning your LCD Display on
When press the POWER button, the LED on the front lower of the TV to switch off and
LCD display on.
Power indicator on -- Power on. Power indicator off -- Power off.
!
◇
Programming TV channels
1 Press the TV/PC button on the remote control to select TV mode.
2 Press the MENU button on your remote control to display the OSD menu.
3 Press the ▲ / ▼ button on your remote control to highlight TV and press + button to
select it.
4 Press the ▲ / ▼ button on your remote to highlight CHANNEL-SCAN and press +
button to select YES to start the tuning process. (This process will take a few minutes.
The tuning process will find all available channels.)
5.You can now watch TV. Change channels by pressing the CH▲ and CH ▼ buttons.