Nexen CSB 75 960764 User Manual
Page 4
FORM NO. L-21201-B-0606
Figure
Mounting a TA or SA Brake
Nut
Washer
Bolt Head
Anti-Rotation
Slot
Safety
Chuck
Brake
Clearance Between Brake
and Adapter Plate
Adapter
Plate
SAFETY ChuCK pREpARATION
1. Remove orange cap from the back of the Safety
Chuck.
If applicable, remove threaded inserts from the four
mounting holes on the back of the Safety Chuck.
2. Apply Loctite®242 or equivalent to the low head
cap screw provided with the Adapter Kit.
3. Mount adapter plate on back of the Safety Chuck
using a minimum of four low head cap screws.
NOTE: Be sure that the plate is properly aligned, so it
does not rub on the shaft of the Safety Chuck.
4. Tighten the low head cap screws using the torque
value listed in Table 1.
STANDARD OR ADvANCED T- SERIES AND
S-SERIES BRAKE ADApTER KIT
1. Install the flat washer on the cap screw.
2. Slide cap screw and washer into one of three
mounting holes in the Adapter Plate. Choose the
hole based on where you want the brake air inlet
oriented. It is best to orient the inlet towards the
bottom of the brake to facilitate the drainage of any
moisture from the assembly.
NOTE: The bolt head should be facing away from the
Safety Chuck.
3. Apply Loctite®242 or equivalent to the screw
threads and secure nut to the Adapter Plate using
the recommended tightening torque listed in Table
2.
4. Mount the brake on the shaft following the instruc-
tions provided with the brake. Align the anti-rotation
slot with the head of the cap screws in the adapter
plate.
5. Secure the brake to the shaft allowing a minimum
amount of clearance between the brake and the
adapter plate.
NOTE: Make sure that the brake hub does not come
in contact with the low head cap screws used to
mount the plate to the Safety Chuck.
Table 1
Table
Screw Type
Tightening Torque
M5
8 Nm [75 in-lbs]
M6
14 Nm [125 in-lbs]
M8
28 Nm [250 in-lbs]
M10
45 Nm [400 in-lbs]
M12
101 Nm [900 in-lbs]
Jam Nut
Tightening Torque
.250-20
7 Nm [58 in-lbs]
.375-15
24 Nm [216 in-lbs]
.500-13
38 Nm [335 in-lbs]
- CSB 125 P 960764 CSB 125 F 960764 CSB25P 960772 CSB50P 960772 CSB25P 960758 CSB25P 960759 CSB50P 960759 CSB50P 960760 CSB 75 960762 CSB 125 P 960762 CSB 125 F 960762 CSB 75 960763 CSB 125 P 960763 CSB 125 F 960763 CSB 150 P 970254 CSB 150 F 970254 CSB 150 P 970255 CSB 150 F 970255 CSB 150 P 970256 CSB 150 F 970256 CSB 150 P 970257 CSB 150 F 970257 CSB 175 P 970258 CSB 175 F 970258 CSB 175 P 970259 CSB 175 F 970259