Nexen TSE-450 818862 - Manual (Page 10)

10
FORM NO. L-20077-U-0512
PARTS REPLACEMENT
FRICTION FACINGS
NOTE: Refer to Figure 6.
1. Align the holes in the Friction Disc Hub (Item 1) with
the Machine Screws (Item 14) holding the split Friction
Facing (Item 5).
2. Remove the old Machine Screws (Item 14).
3. Remove the old split Friction Facings (Item 5).
4. Install the new split Friction Facings (Item 5).
5. Secure the new split Friction Facings (Item 5) using
the new Machine Screws (with locking patch) (Item
14).
6. Tighten the new Machine Screws to the recommended
torque (See Table 6).
FIGURE 6
Align holes in
Friction Disc Hub
(Item 1) with
Machine Screws.
Friction Facing
(Item 5)
Machine
Screw
(Item 14)
TABLE 6
Item 14 Item 1 Item 5 Item 3 Item 4 Item 8 Item 9 Item 2 Item 12 Item 11 Item 10
Item 16 Item 7
BEARING, COMPRESSION SPRINGS, AND 0-RING SEALS
FIGURE 7
Item 13
Item 15
Item 24 Item 6
NOTE: Refer to Figure 7.
1. Alternately and evenly remove the Shoulder or Socket
Head Cap Screws (Item 6).
2. Remove the Cylinder (Item 10).
3. Remove the Compression Springs (Item 7).
NOTE: For TSE-800-1 units the Spacer (Item 24)
must also be removed.
4. Remove the O-ring Seals (Items 11 and 12).
5. Remove the Socket Head Cap Screws (Item 16).
l e d o M l e d o M l e d o M l e d o M l e d o M s e u q r o T g n i n e t h g i T s e u q r o T g n i n e t h g i T s e u q r o T g n i n e t h g i T s e u q r o T g n i n e t h g i T s e u q r o T g n i n e t h g i T
0 5 4 - E S T ] m N 0 . 3 [ . s b L . n I 0 . 6 2
0 0 6 - E S T ] m N 0 . 3 [ . s b L . n I 0 . 6 2
1 - 0 0 8 - E S T ] m N 7 . 9 [ . s b L . n I 6 8
0 0 0 1 - E S T ] m N 7 . 9 [ . s b L . n I 6 8
CAUTION
Shoulder and Socket Head Cap Screws
are spring loaded. Always wear safety
goggles when working with spring or
tension loaded fasteners or devices.
CAUTION
Spring Housing and Piston Plate are spring
loaded. Spring Housing and Piston Plate
can spring apart, resulting in personal injury
if Spring Housing and Piston Plate are not
clamped together.