Nexen 5H100PSE-E 913108 - Manual (Page 4)

4
FORM NO. L-20288-A-1199
TROUBLESHOOTING
PROBLEM PROBABLE CAUSE SOLUTION
Failure to Engage.
Damaged engagement springs. Contact Horton.
Unexhausted air due to control
valve malfunction.
Replace control valve.
Lack of lubrication in air chamber.
Check air chamber lubrication (See
Lubrication).
Using rigid pipe or tubing for air
line connections. Use flexible tubing for air line
connections.
Using a rigid coupling connected
directly to the Drive Flange.
Contact Horton.
Failure to Disengage.
Control valve malfunction or low
air pressure. Check system for air leaks or
replace control valve.
Using rigid pipe or tubing for air
line connections. Use flexible tubing for air line
connections.
Using a rigid coupling connected
directly to the Drive Flange.
Contact Horton.
Lack of lubrication in air chamber.
Check air chamber lubrication (See
Lubrication).
Tooth Wear or Clicking Sound.
Excessive engagement RPM, or
unintentional disengagement due to
torque overload.
Contact Horton for specifications.
Bearing Failure.
Stay within the specified speed limits as specified in the APPLICATION
CONSIDERATIONS section, Page 2.
Avoid applying excessive overhung loads to Pilot Mount 5HP Tooth
Clutches. Wide pulleys or sprockets which extend beyond the end of the
clutch will increase the radial load and reduce bearing life.
DANGER
Never attempt to disassemble the 5H100P-SE. The 5H100P-SE is a spring engaged unit. Attempting to disassemble this unit
could result in severe injury or death and will void the warranty. If service is required, return the unit to Nexen.
WARRANTY
Nexen Group, Inc. (Nexen) warrants its product(s) [the Product(s)] will be free
from defects in materials and workmanship under normal use and service
conditions for a period of 12 months from the date of shipment. NO OTHER
WARRANTIES, WHETHER EXPRESS, IMPLIED, OR STATUTORY, INCLUDING
WITHOUT LIMITATION WARRANTIES OF MERCHANTABILITY, OR OF FIT-
NESS FOR A PARTICULAR PURPOSE, ARE GIVEN, AND ALL SUCH OTHER
WARRANTIES ARE HEREBY EXPRESSLY DISCLAIMED.
Conditions
This warranty applies only if: (a) the Product has been installed, used, and
maintained in accordance with any applicable Nexen installation or mainte-
nance manual for the Product; (b) the alleged defect is not attributable to
normal wear and tear; (c) the Product has not been altered, misused, or used
for purposes other than those for which it was intended; and (d) the claimant
has complied with the warranty claim procedures set out below in Warranty
Claim Procedures.
Exclusive Remedy
The sole and exclusive remedy for a breach of this warrant shall be, at
Nexen’s sole election, repair or replacement with new, serviceably used or
reconditioned Product, or issuance of a credit in the amount of the current
Nexen discounted price for the Product.
Limitation of Damages
In no event shall Nexen be liable for any consequential, indirect, incidental,
or special damages of any nature whatsoever, including without limitation,
lost profits arising from the sale or use of the Products.
Warranty Claim Procedures
To make a claim under this warranty, the claimant must give written notice of
the alleged defect to Nexen and deliver the Product to Nexen within one year
of the date on which the alleged defect first became apparent.
Nexen Group, Inc.
560 Oak Grove Parkway
Vadnais Heights, MN 55127
800-843-7445
In MN: (651) 484-5900
Fax: (651) 286-1099
www.nexengroup.com
ISO 9001 Certified
Contact NEXEN
Contact NEXEN
Contact NEXEN
Contact NEXEN