Gable mount – TAMKO GABLE MOUNT User Manual
Page 3
GABLE MOUNT
TAMKO SOLAR ATTIC VENT
MODEL 31001283
3
Central District
220 West 4th St., Joplin, MO 64801
800-641-4691
Northeast District
4500 Tamko Dr., Frederick, MD 21701
800-368-2055
Southeast District
2300 35th St., Tuscaloosa, AL 35401
800-228-2656
Southwest District
7910 S. Central Exp., Dallas, TX 75216
800-443-1834
Western District
5300 East 43rd Ave., Denver, CO 80216
800-530-8868
Visit Our Web Site at
tamko.com
REMOTE SOLAR PANEL INSTALLATION
6. Working from inside the attic, find the center of the selected
solar panel location identified in step 2, drill a small hole in
the roof decking large enough for the solar panel wire to fit
through.
7. Working from the roof, feed the solar panel wire through the
hole into the attic.
8. Run a bead of silicone or roof cement around the perimeter of
the underside of the solar panel and around the wire where it
enters the roof, then secure to the roof using nails or screws.
Nail or screw all corners and perimeter of base every 6 inches.
Seal the fastener heads with silicone or roof cement.
9. From inside the attic, apply silicone around the wire where it
enters the roof.
10. Connect the red wire to the negative motor terminal and
the black wire to the positive motor terminal. Tape or tie
extra wire to prevent contact with the fan blade.
11. Remove cardboard from the solar panel and verify that the
ventilator operates.
SERVICE PARTS
(CONTINUED from page 2)
(Continued)
Key
No.
1
2
3
4
Not
Shown
Model
31001283
(Black)
31001343
31001347
31001345
31001372
31001346
Description
Solar Panel Assembly
Fan Blade w/ Set Screw
Motor, DC
Roof Sheet Panel
Brush Kit, DC Motor