TAMKO Peel-N-Stick Felt - Manual (Page 2)

TAMKO
®
PEEL‑N‑STICK FELT
Underlayment
PRODUCT DATA
Rev. 02/2010
tamko.com
Corporate 220 West 4th Street, Joplin, Missouri 64801 800-641-4691
Central District 220 West 4th Street, Joplin, Missouri 64801 800-641-4691
Northeast District 4500 Tamko Drive, Frederick, Maryland 21701 800-368-2055
Southeast District 2300 35th Street, Tuscaloosa, Alabama 35401 800-228-2656
Southwest District 7910 South Central Expressway, Dallas, Texas 75216 800-443-1834
Western District 5300 East 43rd Avenue, Denver, Colorado 80216 800-530-8868
CAUTION: The National Institute for Occupational Safety and Health (NIOSH) has concluded that fumes of
heated asphalt are a potential occupational carcinogen. Do not burn this product.
DESCRIPTION
TAMKO ® PEEL‑N‑STICK Felt is a self‑adhering, asphalt saturated organic felt with a removable split release
film on the adhesive side for ease of installation.
USES
TAMKO PEEL‑N‑STICK Felt is well‑suited for use as an underlayment felt to be applied over the deck prior to
the installation of the final roof covering. It also provides secondary protection against water penetration after
installation of the roof system.
ADVANTAGES
• Self‑Adhering asphalt saturated organic felt — same gauge as No. 15.
• Adheres directly to roof deck for fast and easy installation — no cap nails or
staples needed when installed at temperatures of 35º F and above.
• Split release film eases installation and handling
• Adheres better than traditional mechanically fastened felts — for added wind
resistance and blow‑off resistance. It’s enhanced tear resistance provides a
more durable work surface for installation of the final roof covering.
• Laying lines at 4 in, 18 in, and 32 in. assist in proper alignment.
• U.L. Prepared Roofing Accessory label
LIMITATIONS
• Membrane must not be applied to damp, frosty or contaminated surfaces.
• Membrane must not come into contact with products containing coal‑tar pitch.
• Must be applied at temperatures of 35º F and higher.
PRODUCT DATA*
Roll Size 200 sq.ft.
Roll Dimensions 36" x 72'
Thickness 36 mil
Rolls per 37" x 47" Pallet 30
*All values stated as nominal
TYPICAL PHYSICAL PROPERTIES
ProPerty test Method tyPical Value
Adhesion to Plywood at 75º F ASTM D 1970 50 lbf/ft width
at 40º F ASTM D 1970 5 lbf/ft width
Moisture Vapor Permeability ASTM E 96 (BW) 0.05 perms
Maximum Load ASTM D 1970 25 lbf/in.
Elongation Modified Bitumen Portion ASTM D 1970 75 %
Low Temp. Flexibility ASTM D 1970 ‑20 ºF
Waterproof Integrity of Lap Seam ASTM D 1970 Pass
Tear Resistance ASTM D 1970 40
Breaking Strength at 73º F ASTM D 4869 25