Ryobi RTS20 - Manual (Page 20)

20
ASSEMBLY
TO ASSEMBLE THE SLIDING TABLE
ASSEMBLY
See Figures 17 - 18.
To install sliding table assembly:

Locate the sliding table assembly.
 Unlock the front and back table locking levers.
 Insert sliding table assembly into table locking levers.
 Push the table assembly until it rests against the saw
table and is completely closed.
 Install phillips head screw into hole at end of the rear
extension rod to hold sliding table assembly into locking
levers.
 Lock the front and back table locking levers.
To install indicator:

Locate the indicator.
 Slip the indicator in the slot on the front rail. Fit the top
slot in the indicator over the detent on the end plug and
the bottom slot over the screw hole on the end plug.
 Insert a screw into the bottom slot of the indicator, the hole
in the end plug and the extension rod. Tighten securely,
but do not overtighten. Overtighting may crush extension
rod ends.
Fig. 18
SCREW
SLIDING
TABLE
ASSEMBLY
INDICATOR
TABLE
LOCKING
LEVER
REAR
EXTENSION ROD
EXTENSION
ROD
Fig. 17
END PLUG