Ryobi BTS16 - Manual (Page 25)

25
OPERATION
TO USE THE SLIDING TAbLE EXTENSIONS
See Figure 27.
The sliding table extensions provide the operator with ad-
ditional table width for supporting wider workpieces. This
product has two: one on the left and one on the right side
of the place. There are locking levers under both the front
and back rails that lock the extensions in place or unlock
the extensions for use.
 Pull the front table locking lever toward you to unlock the
lever. Repeat with the back lever.
 Slide the table extension to the desired width.
NOTE: Use the scale on the front rail when a specific
width is desired.
 Once the extension tables are set to the desired width,
relock the front and back locking levers by pushing the
levers back towards the saw base.
TO USE THE OUTFEED SUPPORT
See Figure 28.
The outfeed support slides to give the operator additional
support for cutting long workpieces.
 With the table saw in the
OFF position, stand behind the
saw.
 Grasp the outfeed support with both hands and pull it
until it is fully extended.
Fig. 28
outFeed
SuPPort
Fig. 27
loCKinG
leVer
taBle
extenSion
taBle
extenSion