Dimplex DF3015 - Manual (Page 9)

FREQUENCY INTERFERENCE
If the fireplace does not respond properly to the remote control, the remote operating
frequency may have to be reset. The remote control can send another frequency code to the
circuit board to eliminate interference.
1. Simultaneously press the “SLEEP TIMER DOWN” button and the “PURIFIRE LOW
SPEED” button on the remote control.
2. “COD” will appear in place of the sleep timer digits.
3. Release the “SLEEP TIMER DOWN” button and the “PURIFIRE LOW SPEED” button.
4. Press the initialization button on the unit.
5. press the button on the remote.
Your remote will now have a different frequency communicating with the fireplace.
REMOTE CONTROL FUNCTIONS
FLAME/HEAT ON/OFF BUTTON
Press the “Flame/Heat On/Off “button to turn the Flame/Heat function ON. When the “Set
Temperature” is higher then the “Room Temperature” the heat will come on. To turn the
heat off, lower the “Set Temperature” so that it’s setting is lower then the “Room
Temperature”. The default temperature setting is 72°F (22°C).
NOTE
When using the remote control the heater runs on a thermostat. Press the “Temperature Up”
or “Temperature Down” button to adjust the set temperature. Once the desired set
temperature is reached the heater will turn OFF. The heater will cycle ON and OFF to
maintain the desired set temperature.
FIGURE 5
7
Temperature Up
Temperature
Down
Dimmer
Down
Dimmer Up
Flame Speed
Down
Flame Speed Up
Sleep Timer
Down Sleep Timer Up
Purifire Low
Speed
Purifire High Speed
Flame & Heat
On / Off
Purifire On / Off
Batteries
Child Lock
Purifire
Room Temperature
Set Temperature
Dimmer
Flame Speed Control
Sleep Timer