Ryobi ZR51950A - Manual (Page 26)

26 27 Warranty
Warranty
RYOBI TECHNOLOGIES, INC. LIMITED WARRANTY FEDERAL AND CALIFORNIA
EMISSION CONTROL SYSTEMS NON-ROAD AND SMALL OFF-ROAD ENGINES
The U.S. Environmental Protection Agency (EPA), the California Air Resources Board (CARB), and Ryobi Technologies, Inc. are
pleased to explain the Emission Control System Warranty on your non-road or small off-road engine. In California, new small
off-road engines must be designed, built and equipped to meet the state’s stringent anti-smog standards. In other states, new
2000 and later model year non-road engines must be designed, built, and equipped, at the time of sale, to meet the U.S. EPA
regulations for small non-road engines. The non-road engine must be free from defects in materials and workmanship which
cause it to fail to conform with U.S. EPA standards for the first two years of engine use from the date of sale to the ultimate
purchaser. Ryobi Technologies, Inc. must warrant the emission control system on your non-road or small off-road engine for
the period of time listed above provided there has been no abuse, neglect, or improper maintenance of your non-road or small
off-road engine.
Your emission control system may include parts such as the carburetor or fuel injection system, the ignition system, and the
catalytic converter. Also included may be hoses, belts and connectors, and other emission related assemblies.
Where a warrantable condition exists, Ryobi Technologies, Inc. will repair your non-road or small off-road engine at no cost to
you, including diagnosis (if the diagnostic work is performed at an authorized dealer), parts, and labor.
MANUFACTURER’S WARRANTY COVERAGE:
The 1995 and later small off-road engines are warranted for two years in California. In other states, 1997 and later model year
non-road engines are also warranted for two years. If any emission-related part on your engine is defective, the part will be
repaired or replaced by Ryobi Technologies, Inc. free of charge.
OWNER’S WARRANTY RESPONSIBILITIES
(a) As the non-road or small off-road engine owner, you are responsible for the performance of required maintenance listed in your
operator’s manual. Ryobi Technologies, Inc. recommends that you retain all receipts covering maintenance on your non-road or
small off-road engine, but Ryobi Technologies, Inc., cannot deny warranty solely for the lack of receipts or for your failure to ensure
the performance of all scheduled maintenance. Any replacement part or service that is equivalent in performance and durability
may be used in non-warranty maintenance or repairs, and shall not reduce the warranty obligations of the engine manufacturer.
(b) As the non-road or small off-road engine owner, you should be aware, however, that Ryobi Technologies, Inc., may deny you
warranty coverage if your non-road or small off-road engine or a part has failed due to abuse, neglect, improper mainte-
nance, or unapproved modifications.
(c) You are responsible for presenting your non-road or small off-road engine to a Ryobi Technologies, Inc., service dealer as
soon as a problem exists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30
days.
If you have any questions regarding your warranty rights and responsibilities, you should contact a Ryobi Technologies, Inc.,
Customer Representative at 1-800-860-4050.
COVERAGE:
Ryobi Technologies, Inc. warrants to the ultimate purchaser and each subsequent purchaser that your non-road or small off-road
engine will be designed, built, and equipped, at the time of sale, to meet all applicable regulations. Ryobi Technologies, Inc. also
warrants to the initial purchaser and each subsequent purchaser that your non-road or small off-road engine is free from defects in
materials and workmanship which cause the engine to fail to conform with applicable regulations for a period of two years. The 1995
and later small off road engines are warranted for two years in California. In all other states for 1997 and later model years, EPA requires
manufacturers to warrant non-road engines for two years. These warranty periods will begin on the date the non-road or small
off-road engine is purchased by the initial purchaser. If any emission-related part on your engine is defective, the part will be
replaced by Ryobi Technologies, Inc. at no cost to the owner.
Ryobi Technologies, Inc. shall remedy warranty defects at any authorized Ryobi Technologies, Inc. engine dealer or warranty sta-
tion. Any authorized work done at an authorized dealer or warranty station shall be free of charge to the owner if such work deter-
mines that a warranted part is defective. Any manufacturer-approved or equivalent replacement part may be used for any warranty
maintenance or repairs on emission-related parts, and must be provided free of charge to the owner if the part is still under warranty.
Ryobi Technologies, Inc. is liable for damages to other engine components caused by the failure of a warranted part still under warranty.
The California Air Resources Board’s Emission Warranty Parts List specifically defines the emission-related warranted parts.
(EPA’s regulations do not include a parts list, but EPA considers emission-related warranted parts to include all the parts listed
below.)
These warranted parts are: Carburetor, Spark Plug, Ignition, Air Filter, and Fuel Filter.
MAINTENANCE REQUIREMENTS
The owner is responsible for the performance of the required maintenance as defined by Ryobi Technologies, Inc. in the
operator’s manual.
LIMITATIONS
The Emission Control Systems Warranty shall not cover any of the following:
(a) repair or replacement required because of misuse or neglect, lack of required maintenance, repairs improperly performed
or replacements not conforming to Ryobi Technologies, Inc. specifications that adversely affect performance and/or du-
rability, and alterations or modifications not recommended or approved in writing by Ryobi Technologies, Inc., and
(b) replacement of parts and other services and adjustments necessary for required maintenance at and after the first sched-
uled replacement point.
The Emissions Compliance Period referred to on the Emissions Compliance label indicates the number of operating hours for
which the engine has been shown to meet Federal emission requirements. Category C=50 hours, B=125 hours, and A=300
hours.
THE FOLLOWING CALIFORNIA AIR RESOURCES BOARD (CARB) STATEMENT ONLY AP-
PLIES TO MODEL NUMBERS REQUIRED TO MEET THE CARB REQUIREMENTS.