G-Shock AW-570MS-8T - Manual (Page 2)

— 3 —
COUNTDOWN ALARM MODE
The countdown timer can be set within a range of 1 sec-
ond to 60 minutes. When the countdown reaches zero,
an alarm sounds for 10 seconds or until you press any
button.
• If you do not operate any button for a few minutes while
in the Countdown Alarm Mode, the watch goes back to
the Timekeeping Mode automatically, unless a count-
down operation is in progress.
To set the countdown start time
1. Hold down A while in the Countdown Alarm Mode. The
minutes digits flash on the display because they are
selected.
2. Press C to change the selection in the following se-
quence.
3. Press D to increase the selected number or B to decrease it. Holding down either
button changes the selection at high speed.
• To set the starting value of the countdown time to 60 minutes, set 00' 00".
4. After you set the countdown start time, press A to return to the Countdown Alarm
Mode.
• If you do not operate any button for a few minutes while a selection is flashing, the
flashing stops and the watch goes back to the Countdown Alarm Mode automati-
cally.
To use the countdown timer
1. Press D while in the Countdown Alarm Mode to start the countdown timer.
2. Press D again to stop the countdown timer.
• You can resume countdown timer operation by pressing D .
3. Stop the timer and then press A to reset the countdown time to its starting value.
Minutes Seconds
HAND SETTING MODE
When the time shown on the display does not match the
analog setting, use this mode to correct the analog set-
ting.
• If you do not operate any button for a few minutes while
in the Hand Setting Mode, the watch goes back to the
Timekeeping Mode automatically.
Mode indicator
Minutes
Seconds
1/10 second
Mode indicator
Flashing
To set the analog time
1. Hold down A while in the Hand Setting Mode until the
digital time (hour and minutes) starts to flash on the
display.
• The following step changes the hands of the analog time-
piece without changing the flashing digital time.
2. Press D to advance the hand setting of the analog time-
piece. Holding down D changes the hand setting at
high speed.
3. After you set the analog time, press A to return to the
Hand Setting Mode.
• If you do not operate any button for a few minutes while
a selection is flashing, the flashing stops and the watch
goes back to the Hand Setting Mode automatically.