Denon AVR-2807 - Manual (Page 62)

58
ENGLISH
ENGLISH
Advanced Setup – Part 2 Advanced Setup – Part 2
Press D D H H to select the speaker, then press F F G G
to set.
3
Press ENTER . 4
1
2
3
Set the volume of the various speakers so that the sound output
from the speakers and the subwoofer seems to have the same
volume level.
Press D D H H to select “Channel Level”, then press
ENTER .
Press D D H H to select “Test Tone Start”, then press
F F to select “Yes”.
Press F F G G to set.
When “Auto” mode is selected:
Press
F F G G to adjust the volume.
• Test tones are output automatically, in the order shown
below.
Auto:
Adjust the level while listening to the test tones produced
automatically from each speaker.
Test tones are automatically emitted from each speaker.
Manual:
Adjust with the speaker from which the test tone is output
switched manually.
FL
SW
C FR SR
SBL SL
SB
SBR
Setting the Channel Level
The volume can be adjusted within the range –12 dB to +12
dB.
When “Manual” mode is selected:
Press
D D H H to select the speaker, then press F F G G
to adjust the volume.
Press ENTER .
1
2
3
4
-1
4
-2
5
(2 speakers)
(1 speaker)
1
2
3
4
-1 4
-2
• To cancel the setting, press H H and select “Level Clear”, then
press F F and select “Yes”.
• To adjust the channel level separately for the different play
modes after setting the channel level, perform the operation on
page 34.
• Press D D to select “Step”, then press F F G G to change the
amount of variation if so desired.
• The distance changes in units of 0.1 meters (1 foot) or 0.01
meters (0.1 foot) each time the button is pressed. Select the
value closest to the measured distance.
• Please note that the difference of distance for every
speaker should be 6.0 m (20 ft) or less. If you set an invalid
distance, a CAUTION notice, such as screen right will
appear. In such cases, move the appropriate speaker to the
position of the displayed value.
..... L1
..... L2
..... L3
..... L4
..... L5
..... L6
..... L7
..... L8