Toro CCR 2450 GTS Snowthrower 38515 - Manual (Page 5)

105-1980
Reorder part no. 105-3521
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
1.
No parts required – Unfold the handle.
Discharge chute 1
Chute handle 1
Phillips head screws 3
Washers 3
2.
Locknuts 3
Install the discharge chute.
1. Unfolding the Handle
Procedure
1. Cut the plastic tie that secures the control cable to
the handle.
Note: Hold the cable taut to ensure that it stays
connected at the bottom.
2. Loosen the knobs, pull out the handle bolts, and
rotate the upper handle to the operating position
(Figure 3).
G009177
Figure 3
5