Wyred 4 Sound DAC-1 LE User Manual
Page 7
Vista, 7, and 8. There is also a 32 bit and 64 bit version of the ASIO driver. Please be sure to install the
correct driver for your system. The ASIO drivers are not required for audio playback but can be
beneficial in some configurations. If you do choose to install the ASIO drivers be sure to install them
after the standard driver installation is complete. (ASIO is a registered trademark of Steinberg Media
Technologies GmbH.)
A quick install guide for the standard drivers is located below. More detailed instructions
can be found on the FAQ page of the Wyred 4 Sound website.
1. Locate the driver disk supplied with the unit.
2. Insert the CD into the disk drive of your computer
3. Locate the folder that shows the contents of the CD
4. Open the folder that contains the proper drivers for you system (XP or Vista, 7, 8).
5. You will need to double click the correct Setup32 or Setup64 file to initiate the install.
a. Windows XP, Vista & 7: If you are unsure whether you computer is running a 32-bit or
64-bit operating system you can check by clicking the Start button. Next right click My
Computer and then select Properties.
i.
Windows XP will list x64 Edition in the details for 64 bit. If nothing is listed then
the system is 32-bit.
ii.
Windows Vista and 7 will list 32-bit Operating System or 64-bit Operating
System in the details.
b. Windows 8: To determine if your system is 32-bit or 64-bit first hover your mouse over
the lower right hand corner. Next, click Settings and then select PC info.
i.
The System type will say either 32-bit Operating System or 64-bit Operating
System in the details.
6. Once the install process has begun follow the on screen instructions. The install wizard will
prompt you when the process is complete. If you require more detailed instructions please visit
the FAQ page of our website.
7. Connect the DAC to your computer with the supplied USB cable, power the DAC on, and select
the USB input. You may be prompted by an install wizard that additional installation steps are
required. Follow the on screen instructions. The install wizard will prompt you when the
process is complete.
8. It is now necessary to select the Wyred 4 Sound USB interface as the default output device for
your system. The device name will vary depending on the operating system you are using.
a. Windows XP: Wyred 4 Sound Streaming
b. Windows Vista, 7, 8: Digital Output / Wyred 4 Sound USB Driver 1.0.56
WYRED 4 SOUND
DAC-1 LE v1
4235 Traffic Way
Atascadero, CA 93422
PH: 8054669973
FAX: 8054628962
©2014 WYRED 4 SOUND
All rights reserved.
Page 7 of 16