Directed Electronics Avital 3200 User Manual

Page 17

2000 Directed Electronics, Inc.

The engine may be allowed to run for its pre-programmed time

period, or it can be shut down while running during Timer Mode

operation by pressing Buttons

and

again. In either case,

the vehicle will restart every three hours for a total of six opera-

tion cycles. If the system receives a shut-down input while the

engine is running in Timer Mode, the engine will stop, but will

restart, on schedule, again in three hours!

To exit Timer Mode:

Timer Mode can be exited by turning the ignition on with the key

any time the engine is not running. You can also exit Timer Mode

with the remote transmitter by following these steps:

Start the engine by pressing

and

Press and release

Within two seconds press and release

and

again.

The engine will shut down and the parking lights will flash

four times to confirm that Timer Mode has been exited. If the

car has already been remote started, skip Step One.

Whenever the vehicle is remote started, advanced anti-grind cir-

cuitry prevents the starter from engaging, even if the key is turned

to the start position. This prevents damage to the starter motor if

the key is turned to the start position during remote start operation.

NOTE: Anti-grind circuitry only works when the remote start system is
operating the motor and the Failsafe

Starter Kill relay is installed.

Starter Anti-Grind Circuitry