Directed Electronics Avital 3200 - Manual (Page 12)

9
© 2000 Directed Electronics, Inc.
NOTE: For Passive Mode to be effective, the Failsafe ® Starter Kill relay
must be installed.
Pressing for one second disarms the system and unlocks the
doors (if connected). The horn will honk twice (if connected) and
the parking lights will flash twice to confirm disarming of the sys-
tem. The optional Failsafe ® Starter Kill will be deactivated. The sta-
tus LED will turn off, unless the system is programmed for Passive
Mode. In Passive Mode, the status LED will flash rapidly when the
system is disarmed. This indicates that the system will re-engage
the optional starter kill and re-lock the doors (if Passive Locking
has been programmed) in 30 seconds unless the ignition is turned on.
If your remote transmitter is lost or damaged, you can manually
override the optional starter kill. To do this, you must have the ve-
hicle's ignition key and know where the Valet ® switch is located. Be
sure to check with the installer for the location of the Valet ® switch.
To override the optional starter
kill, turnthe ignition on and
press the Valet ® switch within 10
seconds. The status LED will stop
flashing and the vehicle should start. If it does not start, you may
have waited too long; turn the ignition off and repeat the process.
LOCATION OF VALET ® SWITCH_____________________________
DRW-35
Disabling the Optional Starter Kill Without a Transmitter
Unlocking/Disarming