Waldorf 2-Pole - Manual (Page 27)

2-pole Parameters
27 2-pole Analog Filter User´s Manual
Decay
Decay is the rate used for the envelope
to go down.
Threshold
Threshold determines the sensitivity of
the envelope trigger. Signals exceeding
the level trigger the envelope.
If Mode Selector is set to Envelope
Follower, Threshold has no influence at
all.
w
Take a look at the Trigger LED while adjusting the
Threshold
sensitivity.
Hold Time
If Mode Selector is set to Gate Trig-
ger
, Hold Time determines how long
the envelope is in attack phase.
If Mode Selector is set to Pulse
Trigger
, Hold Time determines the
minimum time before any retrigger.
Trigger Button / LED
If Mode Selector is set to Gate Trig-
ger
or Pulse Trigger, you can use the
Trigger button to start the envelope
manually whenever you want. This is
regardless of the Threshold setting.
If Mode Selector is set to Envelope
Follower , the Trigger button has no influence at all.
The Trigger LED lights up, whenever a trigger condition
occurs: either by crossing the threshold level, Trigger
button or a signal to Gate input.